Distribución de Equipos de Telecomunicaciones y Telecontrol. Hardware y Software Informatico

Montaje de Equipos, Venta de Componentes, Cableado, Mecanizado y Rotulación a Medida

 

Convertidores de Interface

ic485IP-1

RS232 to RS422 /RS485 Interface Converter



ic485IP-1.pdf (181KB)
ic485IP-1.pdf (181KB)



Description

The ic485IP Interface Converters provide asynchronous conversion between RS-232 interface and RS-485 standard interface. The RS-232 interface connection is via the unit's DB-25 female connector, while the RS-485 side's connection is via either a five screw terminal block or an RJ-45. The ic485IP converter's circuitry is not electrically isolation between the RS-232 and RS-485 sides. The RS-232 side may operate as DTE or DCE, has provisions for establishing hardware flow control, and has LEDs to indicate data transmission and reception. The RS-485 side may operate in either two wire half duplex or four wire half or full duplex and also has LED's to indicate data transmission and reception.

icCL-2

RS232 Current Loop Converter



icCL-2.pdf (70.83KB)
icCL-2.pdf (70.83KB)


Description

Current loop devices use current on or current off to transmit binary digits. The icCL converter interfaces RS-232 systems to 20mA or 60mA current loop ports with open circuit voltages up to 30 V. This series of converters works without any external power supply. All the units are very easy to implement. Simply connect the appropriate interface cable and select the DCE/DTE type.

V35IP/449IP

RS-232 Interface Powered Family (Converter)



V35IP_449IP.pdf (267.55KB)
V35IP_449IP.pdf (267.55KB)


Description

The RS232IP family of interface converters allows full bi-directional synchronous conversion between RS-232C (V.24) and V.35 or RS-449/530 hardware. These converters all work WITHOUT an EXTERNAL POWER SUPPLY. The RS232IP interface converters are designed for synchronous RS-232 operation at data rates up to and including 128kbps. They may also be applied to asynchronous RS-232 using only TD & RD signals, while ignoring TC, RC, and XTC timing signals. Asynchronous RS-232 requires three times greater data throughput on the synchronous side's V.35 or RS-449/530 interface. The physical connections for all RS232IP family conver ters are DB25 female with standard pin out, while a cable adapter is required for V.35 or RS-449/530 side. All three models may be interchanged as long as the correct V.35 or RS-449/530 cable is applied.

V35/485-1

V.35 Interface Powered Converter



v35_485_1.pdf (39.9KB)
v35_485_1.pdf (39.9KB)


Description

The V35/485-1 Interface Converter provides conversion between V.35 and RS-485 standard interfaces. The V.35 interface connection is via a supplied adapter cable and the unit's DB-25 female connector, while the RS-485 side's connection is via a five screw terminal block. The V35/485-1 converter's circuitry provides a high degree of electrical isolation between the V.35 and RS-485 sides. The V.35 side may operate as DTE or DCE, switch selectable, has provisions for establishing hardware flow control, and has LEDs to indicate data transmission and reception. The RS-485 side may operate in either two wire half duplex or four wire half full duplex.

Vuelva a visitarnos. ¡Gracias por su interés!